Car Dent Repair Puller Kit With 18pcs Hot Melt Glue Tabs

Key Features

• Drawing Gasket Sizing — The larger the drawing gasket, the larger the drawing force, so a large dent needs a large gasket.

Product Specifications

• Piece Count: 18 pcs

What It Is / How It Works

This car dent repair puller is a kit for pulling out dents on a car. It uses hot melt glue sticks in a glue gun to bond a drawing gasket to the dent. A T-shaped repairer and a sliding rod then pull the dent up.

Who It's For / Use Cases

Dent pullers of this type suit car owners who want to work on a dent themselves with a glue gun and simple pulling tools. They fit a hands-on repair approach where the dent is cleaned, glued, pulled and checked in order.

How to Use / Care

1. Clean the dent with a clean wet cloth.
2. Mount the glue stick into the glue gun, pull the trigger to feed the glue stick in, connect the power source and preheat for 5 minutes.
3. Apply the drawing gasket with hot melt glue, using the four holes of the gasket, and press it lightly at the center of the dent. Let the glue cool for about 8 minutes.
4. Align the T-shaped repairer, press the drawing gasket with hot melt glue, then pull the sliding rod backwards to pull up the dent.
5. Check the dent with a line board. If it remains, knock it slightly with a flattening hammer or pen, then clean the repaired area with a clean wet cloth.

How to Choose

Choose the drawing gasket size to match the dent. A small dent suits a smaller gasket, and a large dent needs a large gasket. Make sure you have a glue gun that takes glue sticks, since the steps use one. The 18-piece set gives you the parts listed in the steps.

Frequently Asked Questions

How long does the glue take to cool?
The steps say to let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and a little shorter in winter.

Do I need a glue gun to use it?
The steps use a glue gun with hot melt glue sticks, so a glue gun is needed to apply the drawing gasket.

What size drawing gasket should I use?
Use a proper drawing gasket, and a large dent needs a large one. The larger the gasket, the larger the drawing force.

What if a dent remains after pulling?
Check the dent with a line board. If the dent still shows, knock it slightly with a flattening hammer or pen.